Toyota Sienna Service Manual: Front door

Hood

COMPONENTS Adjustment HINT: Since a centering bolt is used as a hood hinge mounting bolt and hood lock mounting bolt, the hood and hood lock can not be adjusted with them on. Substitute a bolt ...

Disassembly

HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH Using a screwdriver, disengage the clip and claw, and remove the garnis ...

Other materials:

Inspection
1. INSPECT MASS AIR FLOW METER  Visually check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter. OK: There is no foreign matter. If the result is not as specified, replace the mass air flow meter. Measure the resistance according to the ...

Removal
1. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY 2. REMOVE REAR DOOR WINDOW FRAME SUBASSEMBLY 3. REMOVE SIDE TRIM BOARD COVER REAR 4. REMOVE REAR DOOR TRIM BOARD SUBASSEMBLY 5. REMOVE REAR DOOR GLASS RUN 6. REMOVE SLIDE DOOR WINDOW ASSEMBLY 7. REMOVE REAR DOOR GLASS WEATHERSTRIP Put pro ...

Engine Hood Courtesy Switch Circuit
DESCRIPTION The engine hood courtesy switch is built in the engine hood lock assembly. The switch turns on when the engine hood is opened and turns off when the engine hood is closed. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT ENGINE HOOD COURTESY SWITCH Remove the courtesy swi ...