Toyota Sienna Service Manual: Headlight assembly

Taillight Relay Circuit

DESCRIPTION The Multiplex network body ECU controls TAIL relay when signal is received from headlight dimmer switch assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 PERFORM ACTIVE TEST BY IN ...

Components

...

Other materials:

Short to GND in Driver Side Squib 2nd Step Circuit
DTC B1182/19 Short to GND in Driver Side Squib 2nd Step Circuit DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1182/19 ...

Rear blower resistor
ON-VEHICLE INSPECTION 1. INSPECT REAR BLOWER MOTOR CONTROLLER (a) Measure resistance according to the value(s) in the table below.. Standard resistance If the resistance is not as specified, replace the rear blower motor controller. (b) Inspect the rear blower motor controller. (1 ...

Diagnostic trouble code chart
If a malfunction code is displayed during the DTC check, check the circuit listed for that code in the table below. (Proceed to the page given for that circuit.) BACK DOOR CLOSER SYSTEM DTC No. Detection Item Trouble Area B2215 Back Door Closer Switch ...