Toyota Sienna Service Manual: Rear no. 2 Seat assembly (for Manual Seat Type RH Side)

Installation

1. INSTALL REAR NO. 2 SEAT ASSEMBLY LH  Place the rear No. 2 seat assembly LH in the cabin. NOTICE: Be careful not to damage the body.  Install the rear No. 2 seat assembly LH wi ...

Removal

1. REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH  Disengage the clips and remove the seat leg side garnish sub-assembly RH. 2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH  Remove ...

Other materials:

ECM
COMPONENTS REMOVAL 1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (a) Push the right side wall and then push the left wall to release the stoppers. (b) Pull the glove compartment door sub-assembly rearward to remove it. 2. REMOVE NO. 2 INSTRUMENT PANEL BOX (a) Disengage the 2 claws ...

Removal
1. BOLT, SCREW AND NUT TABLE  The bolts, the screws and the nuts, which are necessary for installation and removal of the instrument panel are shown in the illustration below with alphabets. 2. DISCONNECT BATTERY NEGATIVE TERMINAL 3. REMOVE STEERING WHEEL COVER LOWER NO.2 4. ...

Terminals of ECU
1. CHECK OUTER MIRROR CONTROL ECU LH Disconnect the O9 and O10 connectors. Measure the voltage and resistance according to the value(s) in the table below. Voltage Resistance If the result is not as specified, there may be a malfunction on the wire harness side.  Recon ...