Toyota Sienna Service Manual: Rear no. 2 Seat assembly (for Power Seat Type RH Side)

Installation

1. INSTALL REAR NO. 2 SEAT ASSEMBLY  Lock the seat leg rear to the floor striker.  Lock the seat leg front to the floor striker.  Install the rear No. 2 seat assembly with t ...

Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE REAR NO. 2 SEAT LEG SIDE GARNISH SUB-ASSEMBLY  Disengage the 9 clips and remove the rear No. 2 seat leg side garnish sub-a ...

Other materials:

Operation check
NOTICE: Inspection should be started after conforming that the items listed in the "CUSTOMIZE PARAMETER" for the power slide door system have defaulted to the initial settings. 1. CHECK OPENING OPERATION Conditions necessary for the power slide door to open: Power slid ...

On-vehicle inspection
1. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check.  With the front seat side airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seatback as ...

For rear air conditioning system
ON-VEHICLE INSPECTION 1. INSPECT REAR AIR MIX CONTROL SERVO MOTOR (a) Inspect servo motor operation. (1) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the arm turns to "HOT" side smoothly. (2) Connect the po ...