Toyota Sienna Service Manual: Throttle body

Сamshaft timing oil control valve assembly

COMPONENTS ON-VEHICLE INSPECTION 1. INSPECT CAMSHAFT TIMING CONTROL VALVE ASSEMBLY (a) Connect the intelligent tester to the DLC3. (b) Turn the ignition switch to the ON position ...

On-vehicle inspection

1. INSPECT THROTTLE BODY (a) Listen to the throttle control motor operating sounds. (1) Turn the ignition switch to the ON position. (2) When pressing the accelerator pedal position sensor lever ...

Other materials:

Inspection
1. INSPECT CHARCOAL CANISTER ASSEMBLY (a) Visually check the charcoal canister for cracks or damage. If cracks or damage are found, replace the charcoal canister assembly. (b) Check charcoal canister operation. (1) With the purge port closed, blow 1.67 kPa (17.0 gf/cm2, 0.24 psi) ...

Installation
1. INSTALL STARTER ASSEMBLY (a) Install the starter with the 2 bolts. Torque: 37 N*m (380 kgf*cm, 26 ft.*lbf) for bolt (b) Connect the starter connector. (c) Install the terminal nut and cover the nut with the cap. Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf) for nut 2. INSTALL NO. 1 ...

Automatic transaxle fluid
On-vehicle inspection 1. CHECK FLUID LEVEL HINT: Drive the vehicle so that the engine and transaxle are at normal operating temperature. Fluid temperature: 70 to 80°C (158 to 176°F) (a) Park the vehicle on a level surface and set the parking brake. (b) With the engine idling and the ...