Toyota RAV4 manuals

Toyota Sienna Service Manual: Data list / active test

Check mode procedure
HINT: Intelligent tester only: Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode. ...

Data list
HINT: Reading the DATA LIST displayed on an intelligent tester enables values, including those of the switches, sensors, and actuators, to be checked without removing any parts. Reading the DATA L ...

Other materials:

Reverse Signal Circuit
DESCRIPTION The radio and navigation assembly receives a reverse signal from the park/neutral position switch. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT RADIO AND NAVIGATION ASSEMBLY Disconnect the radio and navigation assembly connector R12.  Measure the voltage accor ...

Reassembly
1. INSTALL 2ND BRAKE PISTON O-RING (a) Coat 2 new O-rings with ATF, and install them in the 2nd brake piston. NOTICE: Make sure that the O-ring is not twisted or pinched. 2. INSTALL 2ND BRAKE PISTON (a) Coat the 2nd brake piston with ATF, and install it to the 2nd brake cylinder. NO ...

ECU Power Source Circuit
DESCRIPTION The position control ECU and switch assembly (power seat control switch and ECU) is contained in the switch assembly. During manual operation, only one switch signal is accepted. If signals are input from 2 or more switches simultaneously, all of them are ignored, except when s ...

В© 2011-2025 Copyright www.tsienna.net