Toyota Sienna Service Manual: Rear no. 2 Seat assembly (for Power Seat Type LH Side)

Installation

1. INSTALL REAR NO. 2 SEAT ASSEMBLY RH  Place the rear No. 2 seat assembly RH in the cabin. NOTICE: Be careful not to damage the body.  Install the seat with the bolt. Torque: ...

Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE REAR NO. 2 SEAT LEG SIDE GARNISH SUB-ASSEMBLY  Disengage the 9 clips and remove the rear No. 2 seat leg side garnish sub-a ...

Other materials:

Installation
1. INSTALL REAR DOOR WINDOW FRAME MOULDING Remove the tape from the rear door window frame moulding. Clean the contact surface of the vehicle body with white gasoline. Clean the outer circumference of the rear door window frame moulding with white gasoline. Apply new double-sided ...

On-vehicle inspection
1. INSPECT THROTTLE BODY (a) Listen to the throttle control motor operating sounds. (1) Turn the ignition switch to the ON position. (2) When pressing the accelerator pedal position sensor lever, listen to the running motor. Make sure that no friction noise comes from the motor. If fricti ...

Short to B+ in Curtain Shield Squib LH Circuit
DTC B1168/86 Short to B+ in Curtain Shield Squib LH Circuit DESCRIPTION The curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1168/86 is ...