Toyota Sienna Service Manual: Propeller shaft

Installation

1. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL (a) Using SST(s), install anew transfer extension housing type T oil seal to he transfer extension housing sub-assembly at the position sho ...

Propeller shaft system

PROBLEM SYMPTOMS TABLE Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, ...

Other materials:

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
(a) Preconditions The monitor will not run unless: The MIL is OFF. (b) Drive Pattern (1) Connect an intelligent tester to the DLC3. (2) Turn the ignition switch to the ON position. (3) Clear the DTCs. (4) Start the engine. (5) Allow the engine to idle for 10 minutes or more. ...

Installation
1. INSTALL OUTSIDE MOULDING Using a heat light, heat the mounting surface of the vehicle body between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the body excessively. Remove the tape from the vehicle body. Wipe off the stains with cleaner. Clean the outside moulding (if reusing t ...

Power Back Door does not Operate
DESCRIPTION The power back door operates only when the power back door main switch is ON. The power back door ECU controls the power back door by activating the back door motor (built into the power back door drive unit) to open / close the back door. A request signal from the satell ...