Toyota Sienna Service Manual: 2Gr-fe emission control

Fuel tank

Components REMOVAL 1. DISCHARGE FUEL SYSTEM PRESSURE (See page FU-1) 2. REMOVE CHARCOAL CANISTER PROTECTOR (See page FU-30) 3. REMOVE REAR FLOOR NO. 2 CROSSMEMBER BRACE LH (a) Remov ...

Emission control system

...

Other materials:

Removal
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: Wait for 90 se ...

Checking monitor status
The purpose of the monitor result (mode 06) is to allow access to the results for on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalyst, evaporative emission (EVAP) and thermostat. The monitor result allows the OBD II sc ...

Engine unit
COMPONENTS ...