Toyota Sienna Service Manual: On-vehicle inspection
1. CHECK POWER MIRROR SWITCH OPERATION
- Remote control
The mirror adjust switch can control the adjustment axis of the mirror surface. - Reverse-linked
This function tilts the mirror surface downward to improve the visibility when driving in reverse, provided that all the conditions given below have been met.
- Ignition switch to the on position.
- Shift lever is moved to "R".
2. CHECK MEMORY SWITCH OPERATION
- Memory Memorizes the positions when all conditions below have been met and the 1 or 2 button is pushed while the "SET" button is pushed.
- Ignition switch to the on position.
- Shift position is P.
When the memory setting is completed, the buzzer will sound for 0.5 seconds.
- Recall
If the button 1 or 2 is pressed when all conditions have been met, it recalls the positions.
- Ignition switch to the on position.
- Shift position is P.
If the button 1 or 2 is pressed when all conditions have been met and within 30 seconds, it recalls the positions.
- Ignition switch to the on position.
- Driver door is opened.
- Door Mirror Foot Light Circuit
- Mirror Switch Circuit
- Mirror Motor Circuit
- Position Sensor Circuit
- Memory Switch Circuit
- Power Source Circuit
Data list / active test
1. USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Monitor the ECU data by following the prompts on
the tester screen.
HINT:
The intelligent tester has a & ...
Door Mirror Foot Light Circuit
DESCRIPTION
When the outer mirror control ECU receives the signal(s) from the body ECU
through BEAN
communication, it illuminates the foot light. The foot light is installed on the
bottom of the ...
Other materials:
Removal
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEE ...
Disassembly
1. REMOVE FRONT SEAT SIDE TABLE LEG COVER (w/
Table)
Using a screwdriver, disengage the claws and
remove the seat side table leg cover.
HINT:
Tape the screwdriver tip before use.
2. REMOVE FRONT SEAT SIDE TABLE (w/ Table)
Remove the 4 nuts and seat side table.
Rem ...
Installation
1. INSTALL ROOF HEADLINING ASSEMBLY
w/ sliding roof:
Install the roof headlining with the 5 clips.
w/o sliding roof:
Install the roof headlining with the 3 clips.
NOTICE:
In order to prevent the roof headlining from
becoming bent, work must be performed by 2 or
more persons when ...
