Toyota Sienna Service Manual: Test mode procedure
- Warning light and indicator light bulb check
- Sensor signal check by test mode (signal check) (when using intelligent tester)
- Master cylinder pressure sensor check (when using intelligent tester)
- Speed sensor check (when using intelligent tester)
- Yaw rate sensor check (when using intelligent tester)
- Sensor signal check by test mode (signal check) (when using sst check wire)
- Master cylinder pressure sensor check (when using sst check wire)
- Speed sensor check (when using sst check wire)
- Yaw rate sensor check (when using sst check wire)
Perform zero point calibration of yaw rate and deceleration sensor (when
using sst check wire)
NOTICE:
While obtaining the zero point, do not vibrate the
vehicle by tilting, moving or shaking it and keep it
in a stationary condition. (Do not turn the ignition
switch to the ON position ...
Warning light and indicator light bulb check
(a) Check the warning lights.
(1) Release parking brake pedal.
(2) When the ignition switch is turned to the ON
position, check that the ABS warning light,
BRAKE warning light, VSC warning ...
Other materials:
Inspection
1. INSPECT SHOCK ABSORBER ASSEMBLY FRONT LH
(a) Compress and extend the shock absorber rod and
check that there is no unusual resistance or unusual
sound during operation.
If there is any abnormality, replace the shock
absorber assembly front LH with a new one.
NOTICE:
When disposing of ...
Scratched / Reversed Disc
DTC 62-46 Scratched / Reversed Disc
DTC 63-46 Scratched / Reversed Disc
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
62-46
Scratches or dirt is found on CD surface or CD is set
upside down.
CD
Radio receiver
...
Turn signal lever
Operating instructions
Right turn
Left turn
Lane change to the right (move
the lever partway and release
it)
The right hand signals will flash 3
times.
Lane change to the left (move
the lever partway and release
it)
The left hand signals will flash 3
times.
Turn sign ...
