Toyota Sienna Service Manual: Drive shaft

Installation

1. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY (a) Align the matchmarks on the propeller shaft assembly rear flange and differential companion flange, and connect the shaft with the 4 bol ...

Drive shaft system

PRECAUTION 1. NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (a) When removing and installing the front drive shaft assembly RH in a 4WD vehicle, be sure to first drain all the t ...

Other materials:

Short to B+ in Driver Side Squib 2nd Step Circuit
DTC B1183/22 Short to B+ in Driver Side Squib 2nd Step Circuit DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1183/22 ...

Removal and installation of fuel control parts
(a) PLACE FOR REMOVING AND INSTALLING FUEL SYSTEM PARTS (1) Work in a location with good air ventilation that does not have welders, grinders, drills, electric motors, stoves, or any other ignition sources. (2) Never work in a pit or near a pit as vaporized fuel will collect in those places. ...

Installation
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY  Install the front shoulder belt anchor adjuster assembly with the bolt. Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf) 2. INSTALL CENTER PILLAR UPPER GARNISH 3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY NOTICE: Do not disassemble ...