Toyota Sienna Service Manual: Transfer
- Transfer system
- Transfer oil
- Bearing retainer oil seal
- Transfer assembly
- Transfer unit
- Transfer case oil seal
- Extension housing oil seal
Transfer system
PRECAUTION
NOTICE:
1. Before disassembly, clean the transfer assembly of
any sand or mud to prevent it from entering inside the
transfer during disassembly and assembly.
2. When removing any li ...
Other materials:
SRS Warning Light does not Come ON
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK BATTERY
Measure the voltage of the battery.
Standard voltage:
11 to 14 V
CHECK AND REPLACE BATTERY OR
CHARGING SYSTEM
2 CHECK CONNECTORS
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) term ...
Safety information for Safety Connect
Important! Read this information before using Safety Connect.
Exposure to radio frequency signals
The Safety Connect system installed in your vehicle is a low-power
radio transmitter and receiver. It receives and also sends out radio
frequency (RF) signals.
In August 1996, the Federal Communi ...
Sliding roof switch assembly
ON-VEHICLE INSPECTION
1. INSPECT SLIDING ROOF SWITCH ASSEMBLY
Remove the switch.
Check the resistance between the terminals when
operating the switch.
Resistance
If the result is not as specified, replace the switch
set. ...
