Toyota Sienna Service Manual: Diagnostic trouble code chart
HINT: If a trouble code is displayed during the DTC check, inspect the circuit listed for that code. For details of each code, refer to the relevant page listed under respective "DTC No." in the DTC chart.
TIRE PRESSURE WARNING SYSTEM:
- Transmitter ID1 Operation Stop
- No Signal from Transmitter ID1
- Transmitter ID1 Error
- Abnormal Temperature Inside ID1 Tire
- Transmitter ID not Registered
- Receiver Error
- Initialization not Completed
- Vehicle Speed Signal Error (Test Mode DTC)
- Tire Pressure Warning Reset Switch Circuit
- Tire Pressure Warning Light Circuit
- ECU Power Source Circuit
- TC and CG Terminal Circuit
Data list / active test
1. DATA LIST
HINT:
Using the intelligent tester to read the DATA LIST allows
the values or states of switches, sensor, actuators and
other items to be read without removing any parts. This
non-in ...
Transmitter ID1 Operation Stop
DESCRIPTION
The tire pressure warning valve and transmitters that are installed in the
tire and wheel assemblies
measure the air pressures of the tires. The measured values are transmitted to ...
Other materials:
Removal
1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Push the right side wall and then push the left wall
to release the stoppers.
Pull the glove compartment door sub-assembly
rearward to remove it.
2. REMOVE NO. 2 INSTRUMENT PANEL BOX
Disengage the 2 claws and 4 cl ...
Air outlets
Location of air outlets
The air outlets and air volume
changes according to the
selected air flow mode.
Adjusting the position of and opening and closing the air outlets
Center outlets
Right and left side outlets
Turn the knob to open or close the vent.
Direct air f ...
Checking tires
Check if the treadwear indicators are showing on the tires. Also check
the tires for uneven wear, such as excessive wear on one side of the
tread. Check the spare tire condition and pressure if not rotated.
New tread
Worn tread
Treadwear indicator
The location of treadwear indicator ...
