Toyota Sienna Service Manual: Automatic transaxle system
- Precaution
- Definition of terms
- System description
- How to proceed with troubleshooting
- Road test
- Mechanical system tests
- Hydraulic test
- Manual shifting test
- Initialization
- Monitor drive pattern
- Problem symptoms table
- Terminals of ecm
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Dtc clear
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
Precaution
NOTICE:
Perform the RESET MEMORY (AT initialization) when
replacing the automatic transaxle assembly, engine
assembly or ECM (See page AX-16).
Perform the REGISTRATION (VIN regi ...
Other materials:
How to proceed with
troubleshooting
HINT:
Use this procedure to troubleshoot the front power seat
control system.
The intelligent tester should be used in steps 3 and 5.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS CHECK AND PROBLEM SYMPTOM CHECK
3 CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNI ...
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-28)
3. REMOVE PURGE VSV
(a) Disconnect the purge VSV connector.
(b) Disconnect the 2 purge line hoses from the purge
VSV.
(c) Remove the purge VSV from the air cleaner hose.
(d) R ...
Error in Picture Circuit/ No Current in Back-light/ Excess Current in
Back-light
DTC 34-10 Error in Picture Circuit
DTC 34-11 No Current in Back-light
DTC 34-12 Excess Current in Back-light
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
34-10
Error in power supply system for picture circuit
Radio and navigation assembly
...
