Toyota Sienna Service Manual: Diagnostic trouble code chart
If a DTC is displayed during the DTC check, check the parts listed in the table below and proceed to the page given.
HINT:
- *1: Comes on MIL (Malfunction Indicator Lamp) light up
- *2: "DTC stored" mark means ECM memorizes the malfunction code if the ECM detects the DTC detection condition.
- This DTC may be output when the clutch, brake and gear components etc. inside the automatic transmission are damaged.
- Transmission Range Sensor Circuit Malfunction (PRNDL Input)
- Transmission Fluid Temperature Sensor "A"
- Transmission Fluid Temperature Sensor "A" Performance
- Turbine Speed Sensor Circuit No Signal
- Brake Switch "B" Circuit High
- Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve DSL)
- Pressure Control Solenoid "A" Performance (Shift Solenoid Valve SL1)
- Pressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1)
- Shift Solenoid "D" Performance (Shift Solenoid Valve S4)
- Shift Solenoid "E" Performance (Shift Solenoid Valve SR)
- Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2)
- Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2)
- Intermediate Shaft Speed Sensor "A"
- Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3)
- Pressure Control Solenoid "C" Electrical (Shift Solenoid Valve SL3)
- Shift Solenoid "D" Control Circuit
- Shift Solenoid "E" Control Circuit
- Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT)
- Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT)
- Torque Converter Clutch Solenoid Circuit
Data list / active test
1. DATA LIST
HINT:
Using the intelligent tester to read the DATA LIST allows
the values or states of switches, sensors, actuators and
other items to be read without removing any parts. This
non-i ...
Transmission Range Sensor Circuit Malfunction
(PRNDL Input)
DESCRIPTION
The park/neutral position switch detects the shift lever position and sends
signals to the ECM.
MONITOR DESCRIPTION
These DTCs indicate a problem with the park/neutral position ...
Other materials:
Inspection
1. Inspect heated oxygen sensor (for bank 1
sensor 2)
(a) Measure the resistance of the sensor.
Standard resistance
If the resistance is not as specified, replace the
sensor.
2. HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
(a) Measure the resistance of the sensor.
Standard resistance ...
Stowing the spare tire
Lay down the tire with the outer
side (valve stem) facing up, and
install the holding bracket.
Turn the jack handle clockwise
to raise the tire until the tire is in
the correct position as the jack
handle skips.
Stow the tools.
The compact spare tire
The compact s ...
Differential
SST
RECOMMENDED TOOLS
EQUIPMENT
LUBRICANT
SSM
...
