BMW 3 Series 2018-2023 Owners Manual: Launch Control
Concept
Launch Control enables optimum acceleration on surfaces with good traction under dry surrounding conditions.
General information
The use of Launch Control causes premature component wear since this function represents a very heavy load for the vehicle.
Do not use Launch Control during the break-in, period.
Do not steer the steering wheel when driving off with Launch Control.
Functional requirements
Launch Control is available when the engine is at operating temperature. The engine is at operating temperature after an uninterrupted trip of at least 6 miles/10 km.
Start with launch control
1. Switch on drive-ready state.
2. .png)
Press the button.
TRACTION is displayed in the instrument cluster and the indicator light for DSC OFF lights up.
3. Engage selector lever position S.
4. With the left foot, forcefully press down on the brake.
5. Press and hold down the accelerator pedal beyond the resistance point at the full throttle position, kickdown.
A flag symbol is displayed in the instrument cluster.
6. The starting engine speed adjusts. Within 3 seconds, release the brake.
Repeated use during a trip
After Launch Control has been used, the transmission must cool down for approx. 5 minutes before Launch Control can be used again.
Launch Control adjusts to the surrounding conditions, when used again.
After using Launch Control
To increase vehicle stability, activate DSC Dynamic Stability Control again as soon as possible.
System limits
An experienced driver may be able to achieve better acceleration values in DSC OFF mode.
Shift paddles
Concept
The shift paddles on the steering wheel allow
you to shift gears quickly while keeping both
hands on the steering wheel.
General information
Shifting
The vehicle only shifts at suitable engine ...
Displays
...
Other materials:
Inspection
1. INSPECT MAGNETIC CLUTCH CLEARANCE
(a) Set the dial indicator to the magnetic clutch hub.
(b) Connect the battery positive lead to the terminal 1 of
the magnet clutch connector and the negative lead
to the earth wire. Turn on and off the magnetic
clutch and measure the clearance.
Stand ...
Short to GND in Driver Side Squib Circuit
DTC B0102/11 Short to GND in Driver Side Squib Circuit
DESCRIPTION
The driver side squib circuit consists of the center airbag sensor assembly,
the spiral cable and the
steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0102/11 is recorded when ...
ABS Warning Light Remains ON
DESCRIPTION
If any of the following is detected, the ABS warning light remains on.
The skid control ECU connectors are disconnected from the skid control
ECU.
There is a malfunction in the skid control ECU internal circuit.
There is an open in the harness between the combination meter an ...
