Toyota RAV4 manuals

BMW 3 Series 2018-2023 Owners Manual: Radio

Set-up and use

  1. Changing the entertainment source
  2. Sound output on/off, volume
  3. Programmable memory buttons
  4. Changing the station/track
  5. Waveband/satellite radio

Navigation destination entry

Entering a destination via quick search

1. Press the button on the Controller.

2. "Where to?"

3. Enter at least two letters or characters.

The search term may be completed automatically in gray print.

Press or move the controller up to apply the suggested search term.

4. Select the symbol, if needed.

Results are displayed in a list.

5. "Search location": select search location.

6. Move the Controller to the right.

7. Select desired destination.

Connecting a mobile phone

General information

After the mobile phone is connected once to the vehicle, the mobile phone can be operated using iDrive and the steering wheel buttons.

Connecting the mobile phone via Bluetooth

Via iDrive:

1. "COM".

2. If necessary, select the following setting: "Telephone".

3. "Connect new phone".

4. To perform additional steps on the mobile phone, refer to the mobile phone owner's manual: e.g., search for or connect the Bluetooth device or a new device.

The Bluetooth name of the vehicle appears on the mobile phone display. Select the Bluetooth name of the vehicle.

5. Depending on the mobile device, a control number is displayed or the control number must be entered.

The device is connected and displayed in the device list.

Infotainment
...

Using the phone
Accepting a call Depending on the equipment, incoming calls can be answered in several ways. Via iDrive: "Accept" Press the button on the steering wheel. Via the selection list in the instrum ...

Other materials:

Registration Complete Indication Error/ Registration Demand Transmission/ Multiple Frame Incomplete
DTC 01-E0 Registration Complete Indication Error DTC 01-E3 Registration Demand Transmission DTC 01-E4 Multiple Frame Incomplete DESCRIPTION DTC No. DTC Detection Condition Trouble Area 01-E0 "Registration complete" signal from the master device c ...

Terminals of ECU
1. CHECK TRANSPONDER KEY AMPLIFIER Disconnect the I14 amplifier connector and measure the resistance between the terminal of the wire harness side connector and body ground. If the result is not as specified, there may be a malfunction on the wire harness side.  Reconnec ...

Diagnosis system
1. CHECK DLC3  The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not ...

В© 2011-2023 Copyright www.tsienna.net