Toyota RAV4 manuals

Toyota Sienna Service Manual

Toyota Sienna Service Manual



Initialization
Items to initialize The following items must be initialized for normal system operation after such cases as the battery being reconnected, or maintenance being performed on the vehicle. ...

Introduction
...

Other materials:

Torque converter clutch and drive plate
Inspection 1. Inspect torque converter clutch assembly (a) Inspect the one-way clutch. (1) Set SST into the inner race of the one-way clutch. SST 09350-32014 (09351-32010) (2) Install SST so that it fits in the notch of the converter hub and outer race of the one-way clutch. SST 0 ...

Removal
HINT: Remove the RH side by same procedures with LH side. 1. REMOVE FRONT WHEEL 2. REMOVE FRONT FENDER LINER LH 3. REMOVE FRONT SPEED SENSOR LH (a) Disconnect the speed sensor connector. (b) Remove the sensor harness and clamp from the body. (c) Remove the 2 clamp bolts holding the ...

Reassembly
1. INSTALL NO. 1 SEAT CUSHION FRAME SUBASSEMBLY  Install the seat cushion frame with the bolt. Torque: 20.6 N*m (210 kgf*cm, 15 ft.*lbf) 2. INSTALL RECLINING CONTROL LINK SUBASSEMBLY  Install the reclining control link with the E-ring.  Install the nut. 3. INSTALL RE ...

© 2011-2025 Copyright www.tsienna.net